Описание

Multifunction counter – up to 3 functions in one device.The Codix 524 is a power-supplied multifunction counter with 3 functions in one device:Pulse and position display, frequency and speed display, time counter and short time meter for fast and slow counting pulses. With 6-digit LED display for NPN, PNP input signals.
Mechanical
ModelMultifunction device electronic
FeaturesPulse counterPosition displays without limitsTachometer without limitsHour meters / timers
Dimension 148 x 24 mm | 45 x 22 mm
Protection levelIP65
Working temperature-20 °C ... +65 °C
Weight50 g
Resetelectronic
(1) Installation | Front panel
Electrical
Supply voltage10...30 V DC
Signal inputNPNPNP
Powerful
  •   Fast counter and frequency input, input frequency max. 60 kHz
  •   Robust housing - IP65 protected
  •   Very bright LED display, 8 mm high, 6 digits
  •   Exact and high-precision frequency measurement method (HRA-High Rate Accuracy System)
Frequencies up to 38 Hz are measured by a period duration measurement are evaluated. Frequencies > 38 Hz are controlled via a specialGate time measurement evaluated.Despite a short gate time, a very high accuracy of < 0.1% achieved. The measurement result is available after max. 50 ms.
  •   Short start-up time - Detected after power supply is switched on incoming pulses already after 16 ms => none Pulse loss with simultaneous motor start
User-friendly and universal
  •   Large keys (can also be operated with gloves)
  •   Programming:
  •   Simple and uniform programming and operation by plain text programming.
  •   Access to programming also during operation with safety prompt
  •   Individually adjustable scalingMultiplication and division factor (0.0001 to 99.9999), in order to calculate corresponding units in e.g. position in 1/10 mm and speed to be displayed in /RPM
  •   4 different counter input types for the position display: Counting direction, difference or addition mode, phase discriminator with single, double, or quadruple evaluation
  •   Frequency measurement (display in 1/min or 1/sec)
  •   Time counting: Pulse width or period duration measurement in hours, minutes or seconds, as well as real-time display
  •   Inputs: As an alternative to the HTL inputs, the following devices are also available with 4 to 30 V DC input level for use as a parallel display for PLC
  •   Optional with output: 0 signal for position and counting, Standstill monitoring at speed, 1 Hz cycle during active timing
''